No_4—6．3主要由葉輪、機殼、進風口、支架等組成；N07．1—16主要由葉輪、機殼、進風口、傳動組等組成。
葉輪：9—19型風機葉片為12片，9—26型風機葉片為16片。均屬前向彎曲葉型。葉輪擴壓器外緣最高圓周速度不超過140m／s。葉輪成型后
經靜、動平衡校正，故運轉平穩。
機殼：用普通鋼板焊接成蝸型殼整體。
進風口：做成收斂式流線型的整體結構，用螺栓固定在前蓋板組成。
傳動組：由主軸、軸承箱、聯軸器等組成。主軸由優質鋼制成，軸承箱整體結構，采用滾動軸承，用軸承潤滑脂潤滑。
Fan of N_04—6 3 is mainly consists of impeller,enclosure，air inlet，suppod，etc．；fan of N_07 1—16 is mainly consists of impeller，enclosure，
air inlet，driving unit，etc．．
Impeller：fan Of 9—1 9 type has 1 2 impellers．9-26 type has 1 6 impellers．a(chǎn)ll are forward direction bending types Outer edge of impeller diffuser not over 1 40m／s．The impellers have accepted static and dynamic balance calibration，SO they are able to run smoothly and stably．
Enclosure：it is made of general steel sheets by welding，it is a scroll casing．
Air inlet：it is made into an integral structure with convergence streamline，it is fixed by bolt on the front plate
Driving unit：it is consists of principal shaft，bearing housing，coupling，etc．．The principal shaft is made of high—quality steel，bearing housing has integral structure，adopting rolling bearing and bearing grease for lubrication．