HDMI Splitter 1 x 8 UserManualDear customer Input Video Signal0.5-1.0voltsp-pInput DDC Signal5voltsp-p（TTL)Max Single Link Range1920×1200,1080PHDMI480i/576i/480p/576p/720p/1080i/1080PDVI480p/576i/576p/720i/720p/1080i/1080pHDMI VersionHDMI1.3BandwidthUpto225MHzEDID Duration12secondsPower supplyDC 5V / 3AThank you for purchasing this product. Foroptimum performance and safety, please read these instructions carefully beforeconnecting, operating or adjusting this product. Please keep this manual forfuture reference.Ⅰ.INTRODUCTION 1×8 HDMI splitter distributes1 HDMI source to 8 HDMI displayssimultaneously. Itoffers HD video solution for super market, shopping Mall,HDTV/STB/DVD/Projector/DVR factory, data control center,　information distribution, conference roompresentation, education andtraining, corporation showroom, luxurious house, etc.Ⅱ.SPECIFICATIONS:Ⅲ. CONNECTION AND OPERATION 1). Connect HDMI source and displays into theSplitter.*please refer to the Connection Image.2). Connect the DC 5V/2A power supply into the splitter. Make sure you can not connecta power supply with voltage higher than 5V, or the splitter may get damaged.3).Turn on the power switch.4).When all input and outputs are connected andturned on, the corresponding LED will light. splitter is powered off before you insert andextract HDMI cables,and please insert and extract HDMI cablesgently.Ⅵ.INTERFACE SPECIFICATONS: 1).Power switch 2) HDMIinput LED ItemQtyRemark1×8 HDMI splitter1pcsPower supply1pcsDC 5V@3AUser Manual1pcsEnglish3) HDMI output LED4) HDMI output5) HDMI input 6 )Power Supply SocketV BOX CONTENTS:IV.FAQ:1). The splitter doesn’t appear to befunctioning.Check if the LED lights, the power supply isconnected and the power switch is turned on. Make sure all cables are wellconnected, and in good condition. You’re encouraged to try different cables onthe splitter. Make sure the system of connecting the input source to thedisplays directly works well.2). The LED doesn’t light.Make sure you use the accessory power supply ofthe splitter. Power supply connected with voltage higher than 5V may damage thesplitter.3) If the maximum resolution of the fourdisplays is not the same, what resolution will be displayed?In order to make sure each display worksnormally, the splitter will display at the lowest resolution.IIV.CONNECTION IMAGE: