產品說明
由丙烯酸共聚乳液、顏料、填充料和助劑等組成。該產品遮蓋率高,流平性佳,耐老化性能好.
Instruction
Consist of acroleic acid emulsion, dyestuff, stuffing and assistant. This product is of high cover rate, good tactility and resistance to aging.

施工工藝
基墻處理 涂抗堿封閉底漆或封閉底漆1遍干后,再涂外墻啞光乳膠漆2遍
Construction craft
Foundation wall process: to coat alkali resistance sealing primer paint or sealing primer paint for one time, then coat outer wall dumb latex paint twice.

施工說明
施工方法:刷涂、滾涂、噴涂 稀釋劑：清水5%（最大體積） 施工條件；在正常良好的條件下進行施工
Construction instruction
Construction way: brushing , rolling and spouting. Diluent: water 5%(maximum CM)
construction condition: construct under normal and good condition.
漆膜厚度：干膜35微米；濕膜106微米 重涂時間：最小4小時；最大不限（20℃/68℉，R.H.65%） 工具清洗：清水
Film thickness: dry film 35 micron; wet film 106 micron interval of repaint time: at least 4 hours; no upper limit(20℃/68℉，R.H.65%)
Cleaning: water

表面處理
被涂表面必須干燥、潔凈、無油；結構應堅實，平整無缺陷，PH值小于10。作為膩?zhàn)踊蚋〉竦灼岬拿嫫?，?yīng)待膩?zhàn)踊蚋〉竦灼嵊哺珊?BR>方可涂布。如遇舊漆松散的墻面，應將粉化、剝落的漆層除去，用清水沖洗干凈，待墻面充分干燥方可涂布。
Surface process:
Keep the surface dry, clean and no oil; structure should be firm, flat and no defect. PH value below 10. As paint of putty or emboss primer paint, should never spread coating until the emboss primer paint is hard and dry. If for walls with old paint off or loosen, should remove the loosen paint first, and clean with water, then do coating until the wall is fully dried.

注意事項
1、本產品應存放于陰涼、干燥、不受陽光直射的倉庫中。存放溫度不低于0℃
2、溫度在8℃以下或濕度在85%以上不宜施工。
3、不可與其它油漆、溶劑或粉料等混合使用。
4、本產品密封保質期為二年（20℃/68℉）